Enamel KHS-710 is a one-packing material based on vinyl chloride-vinylidene chloride copolymer.
KHS-710 is used in a complex coating system to protect metal surfaces from corrosive media of alkaline and acidic nature.
Enamel KHS-710 is used on primer KHS-010 or XS-077.
Forms waterproof and benzo-resistant coating withstanding the effects of mineral acids and alkalis, salts, corrosive gases and other chemical reagents having a temperature of no higher than 60 оС.
Appearance of the coating — semi
Colour — gray, and also red-brown when ordering not less than 1 ton
Drying time to grade 3 at 20 ° C — no more than 1 hour
Mass fraction of nonvolatile substances — 27-33%, wt.
The share of nonvolatile substances by volume — 12-16%, vol.
Theoretical consumption per layer — 160-200 g / m2 / 6 , 8-5.4 m2 / l
Recommended thickness of one layer — 20-25 microns
Recommended number of layers — 2
Persistence of complex coating at temperature +60 оС, h, not less, to static action:
— 25% nitric acid — 12
— 25% sulfuric acid — 24
— 25% hydrochloric acid — 12
To dilute the enamel and clean tools use solvent P-4.
When preparing the surface for painting, preliminary priming with XS-010 or XS-077 primers is used.
Application methods: Pneumatic or airless spray.
Application conditions: Before use, make sure that the base of the CS-710 enamel is well mixed and uniform throughout the volume of the container.
If necessary, the materials can be diluted to the working viscosity with solvent P-4 before use.
The prepared enamel is applied to the surface of the protected material by pneumatic or airless spraying.
The application should take place at an ambient temperature of minus 10 ° C to 30 ° C and a relative humidity of not more than 80%.
To prevent condensation of moisture, the surface temperature should be above the dew point by at least 3 ° C.
After drying of the layer of enamel XC-710 (1 hour at a temperature of 20 ° C), subsequent layers are applied.
For washing the tool, the solvent described above can be used.
Before the start of operation in aggressive environments, the coating is aged for 7-14 days, depending on their nature.
Enamel HS-710 is flammable! Do not work near open sources of fire.
Work with enamel to produce with good ventilation, in rubber gloves, with the use of personal protective equipment.
Do not allow to enter the respiratory and digestive organs.
If the enamel gets on the skin, wash it with warm water and soap.
Store the XS-710 indoors in a tightly closed container, excluding direct sunlight and moisture at the ambient air from minus 30 ° C to 30 ° C.
The warranty period of storage of enamel XS-710 is set by the manufacturer — 12 months from the date of manufacture.
By type of material
By type of surface to be protected
Ferrous metals, Primed metal
By field of application
Oil and gas complex, Chemical industry, Metalware / Steel structures, Buildings and constructions / Construction industry
By special properties
Anticorrosion protection of metal, Abrasion resistant coating, For outdoor use, Matte / Half-matt
OOO KONDOR COMPANY
ATT.: SUPPLY DEPARTMENT !!!! R&LD !!
8 (495) 790-14-52
8 (915) 218-57-47
Fax: 8 (495) 223-92-57
8 (812) 318-12-75
8 (812) 318-12-74